Enhanced TDS
Identification & Functionality
- Product Type
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
- Product Highlights
MOBIL 600W CYLINDER OIL offer the following features and potential benefits:
Features Advantages and Potential Benefits Excellent film integrity at high temperatures Excellent equipment protection at high temperatures occasioned by variable load conditions, avoiding unexpected downtime and equipment replacement Provision of good sealing film round rods and in glands in steam applications Excellent resistance to deposit formation at high temperatures Resistant to deposits on areas subject to high spot temperatures, maintaining cleaner systems, requiring less maintenance Excellent anti-wear and low friction properties Additized grades give reduced wear Very good water separation in absence of additives Non-additized grade gives ready separation from condensate High quality and built in performance features Results in fewer unplanned stoppages and reduced maintenance costs
Applications & Uses
- Markets
- Applications
- Application Area
- Application Method
- Product Application
MOBIL 600W CYLINDER OIL is recommended for the following applications:
• The splash lubrication of enclosed worm gears operating at moderate to high speeds and temperatures. (MOBIL 600W CYLINDER OIL)
• Steam cylinders, couplings, bearings, and break-in of compressor cylinders (MOBIL 600W CYLINDER OIL)
• MOBIL 600W CYLINDER OIL and Mobil Extra Heda Super Cylinder Oil are recommended for the above applications but under higher
temperature and load conditions
• Mobil Extra Hecla Super Cylinder Mineral is recommended where ready separation from condensate is essential, for example, where exhaust
steam is used for process work
• Mobil Extra Hecla Super Cylinder Mineral may also be used as a tempering oil for bath temperatures up to 290°C
Properties
- Typical Properties
Value Units Test Method / Conditions Copper Strip Corrosion Rating (at 100°C, 3 h) 1B - ASTM D130 Density (at 15.6°C) 0.9 g/cm³ ASTM D4052 Flash Point 282 °C ASTM D92 Kinematic Viscosity (at 100°C) 28 mm²/s ASTM D445 Kinematic Viscosity (at 40°C) 375 mm²/s ASTM D445 Pour Point -9 °C ASTM D97 Viscosity Index 95 - ASTM D2270